By categories

Integrated Flexible Array Light Bar with Run-Turn-Brake

4801
Price: $53.99 List price: $59.99  
You save: $6.00 (10%)
  • Save 10%
Flexible Array with Run-Brake-Turn

Integrated Flexible Array Light Bar with Run-Turn-Brake

4801
Price: $53.99 List price: $59.99  
You save: $6.00 (10%)
Recommended for proper installation
+
Add to wishlist

New and Improved! Now more flexible and brighter than previous versions

Finally, an all-in-one Motorcycle LED Light Bar that functions as Running Light, Brake Light, and Turn Signals without the need for a special RTB (run/turn/brake) module. This unique LED Light Bar comes in many lengths and features a 1/2 intensity running light and full intensity brake light across the full length of the strip.  Then when either turn signal is applied that 1/2 of the light bar will switch to Amber.

Use them as brake/running/turn signals, third brake lights on trunks, TourPaks, trikes and more....
Many lengths to fit just about any motorcycle fender, trunk or Tour Pak - from  6.2" to over 15" long"

Installation:
- Installs easily with supplied double sided 3M tape (attached to back of fixture at factory).
- Adhesion Promoter Pad (add when ordering) is specifically formulated to be used with 3M™ Acrylic Foam Tape.  Prepares surface for a trouble free, long lasting adhesion.
- Installation instructions included.
- 5 wire hook-up. Wires exit out the back of one end cap. Drilling of small hole required.

** NOTE** Can be flexed in an arc as if to wrap around a paint can. CAN NOT be bent in smiley or frown face direction

Will NOT work on '05 - '08 Hammer, Jackpot, Vegas, and Kingpin or other Victory models with 2-3 volt taillights.

Not DOT approved

  • Available with Clear or Smoked lens
  • Integrated design with red running & brake along entire length of light bar and Amber turn signals on each 1/2
  • Entire light bar illuminates as running and brake
  • As turn signal, left or right side switch from red to amber as blinker
  • 120 degree viewing angle for wider visibility
  • Flexible "D" channel tube that is only .325" thick by .325" wide
  • Industrial strength double sided mounting tape on back
  • 24 gauge teflon coated wire leads that are 2 feet long
  • Input voltage of 12-15 Volts DC
  • Not DOT approved

Universal for all 12V DC Systems.

Will NOT work on '05 - '08 Hammer, Jackpot, Vegas, and Kingpin or other Victory models with 2-3 volt taillights.