By categories

BackOFF Brake Light Module 1001

DS-272352
Price: $37.95  
BackOFF Module

BackOFF Brake Light Module 1001

DS-272352
Price: $37.95  
+
Add to wishlist
The original BackOFF™ Brake Light Module automatically flashes your brake light(s) to capture the attention of following drivers and to make your motorcycle more visible. When installed, the motorcycle's brake light becomes significantly more noticeable because your brake light(s) modulates three short flashes followed by one steady-on pulse for four seconds. This pattern automatically repeats itself as long as the brakes are applied.

Note: This module will not work with LED brake lights. The BackOFF™ XP Brake Light Module with work with both standard incandescent and LED brake lights.

Flash Pattern:
When you apply your brakes, it causes your brake light to automatically emit a visual alerting signal of 3 short light flashes, followed by 1 steady on light for 2 seconds. This signal automatically repeats itself as long as the brakes are applied. This pattern is not random, but has been selected because of its ability to gain and retain following driver's attention.

  • Amp Limit: 10 Amp Max (up to 3 Standard Incandescent Bulbs)
  • System Requirement: 12VDC(-)
  • Attachment Method: Included Double Sided Adhesive Pad
  • Size: 5/8" x 2 1/4" x 1 5/8"
  • Wire Length: 5"-6"
  • Material: Anodized Aluminum Case with Heat and Water Resistant Potting
  • Wire: 16AWG - 20AWG
  • Water Resistant: Yes
  • Heat and Vibration Resistant: Yes

Universal for all 12V DC systems

To install, wire the BackOFF™ Brake Light Module in-line with your existing brake light wire. Locate your brake light wire and cut the wire into 2 (use a test light or multi-meter to find proper wire). Connect the red wire from the BackOFF™ Brake Light Module to the cut wire end leading toward the front of the motorcycle. Next connect the white wire with the red stripe to the cut wire leading toward the rear of the bike. Finally peel the paper lining off of the double sided adhesive pad and mount the module to a clean, flat surface.

Wiring:
Solder connections or use crimp connectors (not included)

Red Wire - Brake Light Wire Leading toward front of Bike
White Wire with Red Stripe - Brake Light Wire Leading toward Bulb

Customers who bought this product also bought: